A user-defined micromechanical model was developed to investigate the fracture mechanism of asphalt concrete （AC） using the discrete element method （DEM）. A three-dimensional （3D） AC beam was built using the ＂Fish＂ language provided by PFC3D and was employed to simulate the three-point bending beam test at two temperature levels： -10 ℃ and 15℃. The AC beam was modeled with the consideration of the microstructural features of asphalt mixtures. Uniaxial complex modulus test and indirect tensile strength test were conducted to obtain material input parameters for numerical modeling. The 3D predictions were validated using laboratory experimental measurements of AC beams prepared by the same mixture design. Effects of mastic stiffness, cohesive and adhesive strength on AC fracture behavior were investigated using the DEM model. The results show that the 3D DEM fracture model can accurately predict the fracture patterns of asphalt concrete. The ratio of stress at interfaces to the stress in mastics increases as the mastic stiffness decreases; however, the increase in the cohesive strength or adhesive strength shows no significant influence on the tensile strength.
In order to study the dynamic responses in the microstructures of the pavement structure, the multi-scale modeling subjected to moving load is analyzed using the discrete element method （DEM）. The macro-scale discrete element model of the flexible pavement structure is established. The stress and strain at the bottom of the asphalt concrete layer under moving load are calculated. The DEM model is validated through comparison between DEM predictions and the results from the classical program. Based on the validated macro-scale DEM model, the distribution and the volumetric fraction of coarse aggregate, mastics and air voids at the bottom of the asphalt layer are modeled, and then the multi-scale model is constructed. The dynamic response in the microstructures of the multi-scale model are calculated and compared with the results from the macro model. The influence of mastic stiffness on the distribution of dynamic response in the microstructures is also analyzed. Results show that the average values and the variation coefficient of the tensile stress at the aggregate-mastic interface are far more than those within the mastics. The dynamic response including stress and strain distributes non-uniformly in both mastics and the interface. An increase in mastic stiffness tends to a uniform distribution of tensile stress in asphalt concrete.
