The effects of solution and aging treatments on the microstructures and mechanical properties of tungsten inert gas arc welded AZ61 magne-sium alloy joints were investigated by microstructural observations,microhardness tests and tensile tests.The results showed that the solution treatment led to the β-Mg17Al12 particles dissolved into the α-Mg grains.Hence,the microhardness of the fusion zone and the ultimate tensile strength of the welded joints were the lowest.With the increase of the aging temperature,the volume fraction of the β-Mg17Al12 particles in the fusion zone increased and this enhanced the microhardness of the fusion zone gradually.Also,the elongation of the welded joints was in-creased slightly with the increase of the volume fraction of the β-Mg17Al12 particles.However,the ultimate tensile strength of the welded joints increased at first and dropped at 190 ?C due to cracks formed at the boundaries of the β-Mg17Al12 particles.
The effects of the types of overlap on the mechanical properties of the friction stir spot welding(FSSW) welded AZ series magnesium alloy joints were investigated by microstructural observations,microhardness tests,and tensile tests.The results show that the micro-structure of the stir zone adjacent to the periphery of the rotating pin is mainly composed of the upper sheet.The average distance D between the longitudinal segment of the curved interface and the keyhole periphery,the tensile shear force,and the microhardness of the stir zone of the FSSW welded AZ61 alloy joint are the highest in all samples.During FSSW of AZ31 and AZ61 dissimilar magnesium alloys,the ir-regular deformation of the longitudinal segment of the curved interface appears,while the microhardness of the stir zone is higher when AZ61 alloy is the upper sheet.Moreover,the microhardness of the stir zone increases initially and then decreases sharply in the longitudinal test position.
The effects of preheat treatments on the microstructures and mechanical properties of tungsten inert gas (TIG)-welded AZ61 magnesium alloy joints were studied by microstructural observations, microhardness tests and tensile tests. The results showed that the vol-ume fraction of the lamellar β-Mg17(Al,Zn)12 intermetallic compound of in fusion zone (FZ) increased from 15% to 66% with an increase in preheat temperature. Moreover, the microhardness of the FZ and the ultimate tensile strength of the welded joints reached their maximum values when the preheat temperature was 300℃ because more lamellar β-Mg17(Al,Zn)12 intermetallic compounds were distributed at the α-Mg grain boundaries and no cracks and pores formed in the FZ of the welded joint.
