YMn2O5nanorods were synthesized through a modified polyacrylamide gel route.The synthesis strategy in this work is based on a sol-gel process using a polyacrylamide gel method in which oxalic acid,citric acid or tartaric acid is employed as the chelating agent.In the gel routes,oxalic acid was used as a carboxyl chelating agent,while citric acid or tartaric acid was a carboxyl and hydroxyl chelating agent.The as-prepared samples were characterized by means of techniques such as X-ray powder diffraction(XRD)measurement,thermogravimetric analysis(TG),differential scanning calorimetry analysis(DSC),Fourier transform infrared spectroscopy(FTIR),X-ray photoelectron spectroscopy(XPS),thermal expansion measurement and field-emission scanning electron microscopy(SEM)investigations.It was found that oxalic acid is the best chelating agent with Y(NO3)3·6H2O and Mn(CH3COO)2·4H2O as precursors to prepare a single orthorhombic YMn2O5nanorods at 1000°C.Scanning electron microscope observation shows that the morphology of YMn2O5powders is significantly dependent on the chelating agent.The peaks(single orthorhombic YMn2O5nanorods)at 642,600,573,546,521,493,486,468,448 and 400cm?1were observed from FTIR spectra.The phase,surface morphology and chelation mechanisms of YMn2O5samples have been discussed on the basis of the experimental results.
WANG ShiFaZHANG ChuanFeiSUN GuangAiCHEN BoXIANG XiaDING QingPingZU XiaoTao
A theoretical study on the red-shift of laser-induced electro-absorption is presented. It is found that laser-induced red-shift scales with the cube root of the pump laser intensity in the optical tunneling regime and has an obvious deviation from this scale in the multi-photon regime. Our results show that in the optical tunneling regime, the laser-induced red shift has the same law as that in the direct current （DC） approximation. Though the scales are the same in the optical tunneling regime, the physical pictures in the two cases are quite different. The electro-absorption in the DC case is a tunneling-assisted transition process, while the laser-induced electro-absorption is a mixed multi-photon process.
A modified polyacrylamide gel route is applied to synthesize SnO2 nanoparticles. High-quality SnO2 nanoparticles with a uniform size are prepared using different chelating agents. The average particle size of the samples is found to depend on the choice of the chelating agent. The photoluminescence spectrum detected at λex = 230 nm shows a new peak located at 740 nm due to the surface defect level distributed at the nanoparticle boundaries.
Modulation caused by surface/subsurface contaminants is one of the important factors for laser-induced damage of fused silica. In this work, a three-dimensional finite-difference time-domain （3D-FDTD） method is employed to simulate the electric field intensity distribution in the vicinity of particulate contaminants on fused silica surface. The simulated results reveal that the contaminant on both the input and output surfaces plays an important role in the electric field mod- ulation of the incident laser. The influences of the shape, size, embedded depth, dielectric constant （er）, and the number of contaminant particles on the electric field distribution are discussed in detail. Meanwhile, the corresponding physical mechanism is analyzed theoretically.
