Carbon-enriched lignocelluloses are regarded as the perfect alternative for nonrenewable fossil fuel, and have a great potential to alleviate the increasing energy crisis and climate change. However, the tightly covalent structure and strong intra and in- ter-molecular hydrogen bonding in lignocellulose make it high recalcitrance to transformation due to the poor solubility in wa- ter or common organic solvents. Dissolution and transformation of lignocellulose and its constituents in ionic liquids have therefore attracted much attention recently due to the tunable physical-chemical properties. Here, ionic liquids with excellent dissolving capability for biomass and its ingredients were examined. The technologies for lignocellulose biorefining in the presence of ionic liquid solvents or catalysts were also summarized. Some pertinent suggestions for the future catalytic conver- sion and unitization of this sustained carbon-rich resource are proposed.
The sunlight is the largest single available source of clean and renewable energy to ensure human society's sustainable development. Owing to their low production cost and high energy conversion efficiency, dye-sensitized solar cells (DSSCs) have been regarded as good alternatives to conventional photovoltaic devices. Herein, a series of composite electrolytes based on poly(ethylene oxide) (PEO) and the binary ionic liquids 1-propyl-3-methy-imidazolium iodide ([PMIm]I) and 1-ethyl-3-methylimidazolium thiocyanate ([EMIm][SCN]) were prepared and then applied to fabricate six DSSCs. The composite electrolytes were characterized by fourier transform infrared spectroscopy (FTIS), X-ray diffraction (XRD), and electrochemical impedance spectra (EIS). It was shown that the addition of binary ionic liquids would reduce the degree of crystallinity of PEO, thus improving the ionic conductivities of the electrolytes by about 2 orders of magnitude. Investigation on the photovoltaic performances of these DSSCs showed that the fill factor (FF) could reach up to 0.67 and energy conversion efficiency (η) could reach up to 4.04% under AM 1.5 full sunlight (100 mW/cm2).
