In machining the particle reinforced aluminum based composite material with high Si content using the cobalt-cemented tungsten carbide micro cutting tools, diamond like carbon （DLC） films are deposited on cobalt-cemented tungsten carbide micro-drills with two-step pretreatment method. Characteristics of DLC coated tools are investigated in bias-enhanced HFCVD system with the optimized hot filament arrangement. The optimization deposition technology is obtained and the wear mechanism of cutting tools is analyzed. The drilling performance of DLC coated tools is verified by the experiments of cutting particle reinforced aluminum based composite material （Si 15% in volume） compared with uncoated ones. Experimental results show that the two-step pretreatment method is appropriate for complex shaped cemented carbide substrates and ensures the good adhesive strength between the diamond film and the substrate. The cutting performance of DLC coated tool is enhanced 10 times when machining the Si particle reinforced aluminum based metal matrix composite compared with that of uncoated ones under the same cutting conditions.
Deposition of diamond thin films on tungsten wire substrate with the gas mixture of acetone and hydrogen by using bias-enhanced hot filament chemical vapor deposition（CVD）with the tantalum wires being optimized arranged is investigated.The self-supported diamond tubes are obtained by etching away the tungsten substrates.The quality of the diamond film before and after the removal of substrates is observed by scanning electron microscope（SEM）and Raman spectrum.The results show that the cylindrical diamond tubes with good quality and uniform thickness are obtained on tungsten wires by using bias enhanced hot filament CVD.The compressive stress in diamond film formed during the deposition is released after the substrate etches away by mixture of H2O2 and NH4 OH.There is no residual stress in diamond tube after substrate removal.
Nanocrystalline diamond films were deposited on Co-cemented carbide substrates using acetone/ H2/Ar gas mixture by bias-enhanced hot filament chemical vapor deposition（HFCVD） technique.The evidence of nanocrystallinity,smoothness and purity was obtained by characterizing the sample with scanning electron microscopy（SEM）,X-ray diffraction（XRD）,Raman spectroscopy,atomic force microscopy （AFM ）,and field emission transmission electron microscopy（FE-TEM ）.The results show that nanocrystalline diamond films consists of nanocrystalline diamond grains with sizes range from 20 to 80 nm and contain a large amount of grain boundaries.The surface roughness of the films is measured as Ra<50nm.The Raman spectroscopy,XRD pattern,and FE-TEM image of the films indicate the presence of nanocrystalline diamond.A new process is used to deposit composite diamond coatings by a two-step chemical vapor deposition procedure,including first the deposition of the rough polycrystalline diamond and then the smooth fine-grained nanocrystalline diamond film.Such composite diamond coatings not only display good adhesion and wear resistant properties,but also have smooth surfaces that are liable to polishing.This coating technology can not only meet the requirement of the adhesion of diamond coatings,but also reduce surface roughness of diamond coatings effectively,thus remove the obstacles for the industrialization of CVD diamond coatings.The diamondcoated dies with these composite coatings show obvious effect in the practical application.
Sun Fanghong~1,Zhang Zhiming~2,Shen Hesheng~2,Guo Songshou~2 (1.School of Mechanical Engineering,Shanghai Jiao Tong University,Shanghai 200240,China
