您的位置: 专家智库 > >

国家自然科学基金(50972119)

作品数:5 被引量:32H指数:4
相关作者:成来飞殷小玮张立同李权刘小瀛更多>>
相关机构:西北工业大学中国航天科工集团更多>>
发文基金:国家自然科学基金教育部“新世纪优秀人才支持计划”高等学校学科创新引智计划更多>>
相关领域:一般工业技术理学机械工程化学工程更多>>

文献类型

  • 5篇中文期刊文章

领域

  • 4篇一般工业技术
  • 1篇化学工程
  • 1篇机械工程
  • 1篇理学

主题

  • 3篇陶瓷
  • 2篇复合材料
  • 2篇复合材
  • 1篇氮化
  • 1篇氮化硅
  • 1篇氮化硅陶瓷
  • 1篇电磁屏蔽
  • 1篇电磁屏蔽效能
  • 1篇渗透法
  • 1篇碳化硅纤维
  • 1篇陶瓷材料
  • 1篇陶瓷化
  • 1篇陶瓷基
  • 1篇陶瓷基复合
  • 1篇陶瓷基复合材...
  • 1篇热解炭
  • 1篇吸波
  • 1篇吸波性能
  • 1篇连接件
  • 1篇螺栓

机构

  • 3篇西北工业大学
  • 1篇中国航天科工...

作者

  • 3篇张立同
  • 3篇殷小玮
  • 3篇成来飞
  • 1篇刘小瀛
  • 1篇李权
  • 1篇李贞
  • 1篇刘建功

传媒

  • 2篇复合材料学报
  • 2篇Journa...
  • 1篇硅酸盐学报

年份

  • 1篇2014
  • 2篇2013
  • 2篇2012
5 条 记 录,以下是 1-5
排序方式:
液硅渗透法制备Si-B-C改性C/C-SiC复合材料被引量:4
2012年
为了降低液硅渗透法制备C/C-SiC复合材料中残留Si的含量,采用浆料浸渗结合液硅渗透工艺制备B12(C,Si,B)3改性C/C-SiC复合材料。通过分析不同比例B4C-Si体系在不同温度的反应产物,确定了B12(C,Si,B)3的生成条件。结果表明:B4C和Si在1300℃开始反应,生成少量B12(C,Si,B)3和SiC,且B12(C,Si,B)3的生成量随反应温度的升高而增加;当B4C和Si的摩尔比为3∶1、反应温度为1500℃时,产物为B12(C,Si,B)3和SiC;液硅渗透法制备的C/C-SiC复合材料相组成为非晶态C、β-SiC和B12(C,Si,B)3,未见残留Si。
刘建功殷小玮成来飞张立同王琴
关键词:复合材料
Dielectric,Electromagnetic Interference Shielding and Absorption Properties of Si_3N_4-PyC Composite Ceramics被引量:2
2013年
Pyrolytic carbon(PyC) was infiltrated into silicon nitride(Si3N4) ceramics by precursor infiltration and pyrolysis (PIP) of phenolic resin,and Ni nanoparticles were added into the phenolic resin to change the electric conductivity of Si3N4-PyC composite ceramics.Dielectric permittivity,electromagnetic interference(EMI) shielding and absorption properties of Si3N4—PyC composite ceramics were studied as a function of Ni content at 8.2—12.4 GHz(X-band).When Ni nanoparticles were added into phenolic resin,the electric conductivity of the prepared composite ceramics decreased with increasing Ni content,which was attributed to the decrease of graphitization degree of PyC.The decrease in electric conductivity led to the decrease in both permittivity and EMI shielding effectiveness.Since too high permittivity is harmful to the impendence match and results in the strong reflection,the electromagnetic wave absorption property of Si3N4—PyC composite ceramics increases with increasing Ni content.When the content of Ni nanoparticles added into phenolic resin was 2 wt%,the composite ceramics possessed the lowest electric conductivity and displayed the most excellent absorption property with a minimum reflection loss as low as -28.9 dB.
Xuan HaoXiaowei YinLitong ZhangLaifei Cheng
关键词:复合陶瓷材料氮化硅陶瓷热解炭SI3N4
Dielectric and Electromagnetic Wave Absorbing Properties of Two Types of SiC Fibres with Different Compositions被引量:7
2013年
The dielectric and electromagnetic properties of two types of SiC fibres with different compositions were investigated. The permittivity and electromagnetic shielding effectiveness (SE) of SiC fibre bundles were measured in 8.2-12.4 GHz by waveguide method. The reflection coefficient (RC) of unidirectional SiC fibre laminates was determined in 8-18 GHz using naval research laboratory (NRL)-arc method. Results showed that the electromagnetic wave (EMW) absorbing properties of SiC fibres were correlated with their composition, microstructure and instinct performance of electrical resistance. SiC fibres with higher content and greater size of nano-scale β-SiC showed higher permittivity, conductivity, SE and lower RC, which resulted in their better EMW absorbing ability, i.e. the lower reflection to EMW.
Fang YeLitong ZhangXiaowei YinYongsheng LiuLaifei Cheng
关键词:碳化硅纤维吸波性能SIC纤维电磁屏蔽效能
液态聚硼硅氮烷的陶瓷化过程被引量:5
2012年
采用Fourier红外光谱、热重–差热以及X射线衍射分析对新型液态SiBNC先驱体进行了结构表征,重点研究了先驱体的陶瓷化过程。结果表明:先驱体以—CH3和—CH=CH2为侧链基团,含有C—H、C=C、Si—H、B—N、N—H、Si—N等化学键;N2气氛保护下的陶瓷产率约为85%,质量损失主要发生在300~800℃;随着温度的升高,聚合物中有机基团逐渐减少,900℃完成无机化转变,得到含有自由碳的非晶态SiBNC陶瓷,1200℃以上非晶态SiBNC陶瓷开始晶化,1500℃得到由C、SiC、Si3N4和BN组成的复相陶瓷。
李贞殷小玮成来飞张立同
关键词:陶瓷
C/SiC陶瓷基复合材料螺栓连接件的振动响应特性及防松性能被引量:14
2014年
通过对C/SiC陶瓷基复合材料螺栓连接件的模态进行计算和试验分析,确定了其模态参数和振动响应特性;然后通过对C/SiC陶瓷基复合材料螺栓连接件进行正弦扫频振动试验,研究了拧紧力矩对螺栓连接件振动性能的影响规律;最后研究了液态聚硼硅氮烷(L-PBSZ)对C/SiC陶瓷基复合材料螺栓连接件防松性能的影响。研究结果表明:一阶和三阶固有计算模态频率与试验模态频率一致,因此可以采用有限元分析方法对C/SiC陶瓷基复合材料螺栓连接件进行振动响应特性分析;采用正弦扫频振动频谱信号差值曲线分析方法可以检测螺栓连接件是否松动;SEM观察表明,L-PBSZ改性的C/SiC陶瓷基复合材料螺栓连接件的螺纹副间形成陶瓷填充体,使得螺纹与螺母间有效摩擦系数和有效摩擦面积增加,因此螺母松脱退出的力矩增大,提高了C/SiC陶瓷基复合材料螺栓连接件的防松可靠性能。
郝秉磊殷小玮刘小瀛张立同成来飞李权
关键词:C/SIC陶瓷基复合材料螺栓连接件模态防松
共1页<1>
聚类工具0