A non-evaporative technique is used to mitigate damage sites with lateral sizes in a range from 50 μm to 400 μm and depths smaller than 100 μm.The influence of the pulse frequency of a CO 2 laser on the mitigation effect is studied.It is found that a more symmetrical and smooth mitigation crater can be obtained by increasing the laser pulse frequency form 0.1 to 20 kHz.Furthermore,the sizes of laser-affected and distorted zones decrease with the increase of the laser pulse frequency,leading to less degradation of the wave-front quality of the conditioned sample.The energy density of the CO 2 laser beam is introduced for selecting the mitigation parameters.The damage sites can be successfully mitigated by increasing the energy density in a ramped way.Finally,the laser-induced damage threshold(LIDT) of the mitigated site is tested using 355 nm laser beam with a small spot(0.23 mm 2) and a large spot(3.14 mm 2),separately.It is shown that the non-evaporative mitigation technique is a successful method to stop damage re-initiation since the average LIDTs of mitigated sites tested with small or large laser spots are higher than that of pristine material.
One of the main factors of laser induced damage is the modulation to incident laser which is caused by the defect in the subsurface of the fused silica.In this work,the repaired damage site irradiated by CO 2 laser is simplified to a Gaussian rotation according to the corresponding experimental results.Then,the three-dimensional finite-difference time-domain method is employed to simulate the electric field intensity distribution in the vicinity of this kind of defect in fused silica front subsurface.The simulated results show that the modulation is notable,the E max is about 2.6 times the irradiated electric field intensity in the fused silica with the damage site (the width is 1.5 μm and depth is 2.3 μm) though the damage site is repaired by CO 2 laser.The phenomenon and the theoretical result of the annular laser enhancement existed on the rear surface are first verified effectively,which agrees well with the corresponding experimental results.The relations between the maximal electric field intensity in fused silica with defect depth and width are given respectively.Meanwhile,the corresponding physical mechanism is analysed theoretically in detail.
