Photoluminescence (PL) and lasing properties of InAs/GaAs quantum dots (QDs) with different growth procedures prepared by metalorganic chemical vapour deposition are studied. PL measurements show that the low growth rate QD sample has a larger PL intensity and a narrower PL line width than the high growth rate sample. During rapid thermal annealing, however, the low growth rate sample shows a greater blueshift of PL peak wavelength. This is caused by the larger InAs layer thickness which results from the larger 2-3 dimensional transition critical layer thickness for the QDs in the low-growth-rate sample. A growth technique including growth interruption and in-situ annealing, named indium flush method, is used during the growth of GaAs cap layer, which can flatten the GaAs surface effectively. Though the method results in a blueshift of PL peak wavelength and a broadening of PL line width, it is essential for the fabrication of room temperature working QD lasers.
Electroabsorption modulators combining Franz-Keldysh effect and quantum confined Stark effect have been monolithically integrated with tunnel-injection quantum-well distributed feedback lasers using a quantum well intermixing method.Superior characteristics such as extinction ratio and temperature insensitivity have been demonstrated at wide temperature ranges.
This paper reports that the complex-coupled distributed feedback laser with the sampled grating has been designed and fabricated.The +1st order reflection of the sampled grating is utilized for laser single mode operation,which is 1.5387 μm in the experiment.The typical threshold current of the device is 30 mA,and the optical output power is about 10 mW at the injection current of 100 mA.
