A combination of photochlorination ofp-xylene and succedent Friedel-Crafts alkylation polymerization was firstly used in the preparation of the hypercrosslinked adsorptive resin. The data of GC-MS and GC showed that a series of chlorizates were produced when p-xylene was photochlorinated. Hypercrosslinked resins could be synthesized by copolymerization, self-polymerization of chlorizates or post crosslinking reaction. The chemical structure and micromorphology of the porous resins were characterized by BET, FF-IR, SEM and elementary analysis （EA）. The results showed that the novel adsorptive resins possess high BET surface near to 1038 m^2/g and large pore volumes range from 0.5 to 1.2 cm^3/g.
Ling Ling Bai Yong Hao Zhou Xiu Li Wang Si Guo Yuan Xian Li Wu
The suspension polymerization with two organic phases was adopted to prepare spherical hyper- crosslinked resin by self-polycondensation of 4,4＇-bis-（chloromethyl）- 1, 1＇-biphenyl （CMB）. The chemical structure,morphology and pore characteristics of the novel spherical resin were characterized with Fourier transform infrared spectroscopy （FTIR）, micrograph and Brunauer-Emmett-Teller （BET）. It is found that the suspension system and stirring speed impose a great influence upon the regularity and size distribution of hypercrosslinked beads. To prepare CMB resin beads with diameter of about 300 μm, the optimal condition is as follows： stirring speed 300 r·min^-1, and the volume ratio of the two organic phases （nitrobenzene/dimethyl silicon oil） 1 ： 5. After the self-polycondensation and sqccedent post-crosslinking of CMB monomer, the spherical adsorbent presents high spec^al surface area （1190 m^2· g^-1） and abundant pore^volume （0.714 cm^3· g^-1）, and could be potentially applied qn the adsorption of various organic molecules and synthesis of porous ion exchanger.
A fibrous strong base anion exchanger （QAPPS） was prepared for the first time via chloromethylation and quaternary amination reaction of polyphenylene sulfide fiber （PPS）, and its physical-chemical structure and adsorption behavior for Cr（VI） were characterized by FT- IR, Energy Dispersive Spectrometry, TG-DTG, elemental analysis and batch adsorptive technique, respectively. The novel fibrous adsorbent could effectively adsorb Cr（VI） over the pH range 1-12, the maximum adsorption capacity was 166.39 mg/g at pH 3.5, and the adsorption behavior could be described well by Langmuir isotherm equation model. The adsorption kinetics was studied using pseudo first-order and pseudo second-order models, and the 4/2 and equilibrium adsorption time were 5 and 20 min respectively when initial Cr（VI） concentration was 100 mg/L. The saturated fibers could be regenerated rapidly by a mixed solution of 0.5 mol/L NaOH and 0.5 mol/L NaCl, and the adsorption capacity was well maintained after six adsorption-desorption cycles.
