The effects of yttrium addition on microstructure and mechanical properties of as-cast Mg-6Zn-3Cu-0.6Zr-xY(x=0,0.5, 1.0,1.5 and 2.0,mass fraction,%)(ZCK630+xY for short in this study)alloys were investigated by means of OM,XRD and SEM. The results show that the average grain size of Mg-Zn-Cu-Zr magnesium alloy is effectively reduced(from 57μm to 39μm)by Y addition.The analysis of XRD indicates the existence of I-phase(Mg3Zn6Y)and W-phase(Mg3Zn3Y2)in ZCK630 alloys with Y addition.The ultimate tensile strength of ZCK630 alloys is significantly deteriorated with increasing Y addition,which is possibly related to the continuous networks of intergranular phases and the increase of W-phase.
New copper alloys with high mechanical properties and high electrical conductivity were prepared, and the effects of addition of minor Mg and Y elements on microstructures and properties were studied. The high tensile strength of above 510 MPa, high elongation of 11%and high electrical conductivity of over 63%IACS can be simultaneously obtained in Cu-0.47Mg-0.20Te-0.04Y alloy after deforming and annealing treatment. Effects of purification together with the grain refining by Y and solid-solution strengthening by Mg are appropriate for enhancing mechanical properties and electrical conductivity of the copper alloys.
New Cu-Mg-Te-Y alloys with high strength and high conductivity were prepared by electromagnetic continuous casting（EMCC）and direct chill casting（DC）.The structures,patterns of elements distributions and mechanical properties of the alloys were investigated.It was found that the equiaxed crystal zone was enlarged and the element Mg and Cu;Te phase were well-distributed by medium-frequency electromagnetic field during continuous casting method.Moreover,the defects and casting impurities were significantly reduced with the addition of electromagnetic,leading to the improvement of the mechanical properties.
