The Pearl River Mouth basin （PRMB） is a marginal sedimentary basin of the South China Sea. It trends NE and is divided into three segments from west to east by two NW-trending faults. Changing dramatically in structures along and across strike, the PRMB is a good example to analyze main factors that might control the process of a continental rift basin＇s extension. Through five series of analogue experiments, we investigate the role of different factors, such as pre-existing discontinuities of crust, rheological profiles of lithosphere, kinematics of extension and presence of magmatic bodies and strong crustal portions （rigid massifs） on the development of basin＇s structures. After being compared with the architecture of the natural prototype, the results of the analogue models were compared with the architecture of the natural prototype and used to infer the role of the different factors controlling the formation and evolution of the PRMB. The main conclusions are as follows. （1） Affected by pre-Cenozoic structures, the PRMB was controlled by crosscut NE- and NW-trending initial faults, and the NW-trending Yitong＇ansha （--~l~） fault may be a through-going fault along dip and offset the NE-trending rift and faults, while the Enpingdong （和统暗沙） fault might exist only in the middle and south. （2） The NW-trending faults may orient WNW to be sinistrally transtensional under SE to nearly NS extension. （3） The thickness ratio of brittle over ductile crust in Baiyun （白云） sag is lessthan normal, suggesting an initially hot and weak lithosphere. （4） The magma must have taken part in the rifting process from early stage, it may occur initially upon or slightly south of the divergent boundary in the middle segment. The flow of magma toward rift boundary faults caused extra vertical subsidence above the initial magma reservoir without creating a large extensional fault. （5） The rigid massif contributed to the strain partition along and across basin strike.
Affected by thermal perturbation due to mantle uprising, the rheological structure of the lithosphere could be modified, which could lead to different rifting patterns from shelf to slope in a passive continental margin. From the observed deformation style on the northern South China Sea and analogue modeling experiments, we find that the rift zone located on the shelf is characterized by half grabens or simple grabens controlled mainly by long faults with large vertical offset, supposed to be formed with normal lithosphere extension. On the slope, where the lithosphere is very hot due to mantle upweUing and heating, composite grabens composed of symmetric grabens developed. The boundary and inner faults are all short with small vertical offset. Between the zones with very hot and normal lithosphere, composite half grabens composed of half grabens or asymmetric grabens formed, whose boundary faults are long with large vertical offset, while the inner faults are relatively short. Along with the thickness decrease of the brittle upper crust due to high temperature, the deformation becomes more sensitive to the shape of a pre-existing weakness zone and shows orientation variation along strike. When there was a bend in the pre-existing weakness zone, and the basal plate was pulled by a clockwise rotating stress, the strongest deformation always occurs along the middle segment and at the transition area from the middle to the eastern segments, which contributes to a hotter lithosphere in the middle segment, where the Baiyun （白云） sag formed.
